Introduction of Quality oxygen compressor factory
Quality oxygen compressor factory refers to the compressor used to pressurize and deliver oxygen. Oxygen is a violent combustible agent, which can easily cause combustion and explosion. When designing and using a Quality oxygen compressor factory, you should pay attention to:
(1) The compressed gas parts of the Quality oxygen compressor factory are strictly prohibited from contact with oil. The cylinders do not use oil but are lubricated with water and glycerin or oil-free. Do not allow oil to be contaminated during maintenance, and must be cleaned and dried with solvents before assembly;
(2) Since the humidity is high when lubricated with water, and the temperature rises again when compressed, the oxygen from the wet gas tank is corrosive, so the materials exposed to oxygen should be corrosion-resistant, and require good thermal conductivity and electrical conductivity. The cylinder of the Quality oxygen compressor factory is generally made of phosphor bronze, the piston is made of aluminum alloy, and the intercooler is made of copper or stainless steel pipe;
(3) The average speed of the piston in the Quality oxygen compressor factory should be lower, and the gas speed in the pipeline should also be lower than that in the air compressor; (4) The exhaust temperature should not be too high, and it should not be higher than 100~12C when lubricated with water, not higher than 160°C when using an oil-free lubricated structure filled with polytetrafluoroethylene. The pressure ratio of each stage should not be too high.
Through the above introduction and analysis of the Quality oxygen compressor factory, hope it helps you.