Installation of Low price oxygen compressor products
When installing Low price oxygen compressor products, the debris in the pipe was not cleaned or the welding slag in the pipe was not ground off with an angle grinding wheel. Under the impact of long-term air flow, the spalling enters the cylinder. During the long-term operation of Low price oxygen compressor products, due to material fragmentation, valve plates, cotter pins, gaskets, and other fragments enter the cylinder, which may cause accidents.
Chaotic management and low quality of employees can also cause accidents. For example, Low price oxygen compressor products found that the secondary and tertiary pressures were over-pressurized, and due to improper operation, an oxygen compressor combustion explosion accident was caused.
Check valves that cause accidents. Low price oxygen compressor products may have a combustion accident, and the initial cause of the combustion is the check valve (this check valve is a gravity lift type).
The failure of the alarm and interlock system of Low price oxygen compressor products will cause accidents. The interlocking failure of shaft radial displacement, shaft temperature, oil pressure, oil temperature, gas seal, oxygen outlet pressure, etc. will cause damage to the oxygen compressor, and in severe cases, it will cause accidents of machine destruction and injury.
Through the above introduction and analysis of the installation of Low price oxygen compressor products, hope it helps you.