图片名称

09

2022

-

10

Engineering Principles of quality Explosion Compressor suppliers china Refrigeration

Author:



When the air conditioner of the heat pump type quality Explosion Compressor suppliers china is operating in the cooling condition, the three-way valve is reversed to connect all components. At this time, the indoor heat exchanger in the quality Explosion Compressor suppliers china becomes the evaporator, and the outdoor heat exchanger becomes the condenser.

quality Explosion Compressor suppliers china
The low-temperature and low-pressure superheated gas from the indoor heat exchanger enter the gas-liquid separator through the four-way valve and the muffler. After the liquid is separated, the hot gas is sucked and compressed by the quality Explosion Compressor suppliers china to become a high-temperature and high-pressure gas. The gas enters the outdoor heat exchanger through the four-way valve to release heat and condense, becoming a subcooled liquid.
After the supercooled liquid is depressurized by capillary resistance, it becomes a low-temperature and low-pressure two-phase fluid, which enters the indoor heat exchanger to evaporate and absorb heat (at this time, the indoor air is cooled), and then enters the next cycle through the four-way valve and the gas-liquid separator again: filter It is mainly used for the separation of refrigerant and oil of quality Explosion Compressor suppliers china to ensure the heat exchange efficiency of the heat exchanger.
Through the above introduction and analysis of the Engineering Principles of quality Explosion Compressor suppliers china Refrigeration, hope it helps you.