图片名称

15

2022

-

11

Wholesale co2 compressor on sales solution to the problem

Author:



First, there may be the following two reasons for the pressure rise to a certain extent of Wholesale co2 compressor on sales. 1. The intake valve of the next stage of the Wholesale co2 compressor on sales or the exhaust valve of this stage leaks, and the gas leaks into the cylinder of this stage. 2. Exhaust valves, coolers, and pipes are dirty, blocking passages.

co2 compressor on sales
Solution. 1. Clean the intake and exhaust valves of the Wholesale co2 compressor on sales, check the valve plates and springs, then repair the valve seats. 2. Clean the cooler and pipes. 3. Check the piston rings, then insert the lock positions into each other.
Second, there may be three reasons why the Wholesale co2 compressor on sales has a certain level of pressure drop. 1. Intake valve leakage level. 2. At this stage, the piston ring wears and leaks, and the piston ring wear and fails. 3. The pipeline connection is not sealed, resulting in air leakage. Solution: 1. Clean the exhaust valve, check the valve spring and valve plate, and trim the valve seat plane. 2. The piston ring lock was misaligned and the piston ring was replaced. 3. Tighten the joint or change the gasket.
Through the above introduction and analysis of the Wholesale co2 compressor on sales solution to the problem, hope it helps you.