图片名称

28

2022

-

12

The working process of Quality Screw compressor Manufacturers china

Author:



Introducing the twin-screw main engine, the working process of Quality Screw compressor Manufacturers china, the volume of the interdental element (that is, the working volume formed by each pair of teeth) gradually expands with the rotation of the rotor, and it is the same as the lower left of the machine of Quality Screw compressor Manufacturers china's air inlet orifice is connected, the gas enters the volume of the element through the orifice, and the air intake process begins;

Quality Screw compressor Manufacturers china
After the rotor of Quality Screw compressor Manufacturers china rotates to a certain angle, after the volume of the interdental element exceeds the position of the air inlet hole, it is disconnected from the air inlet hole, and the air intake process ends; after the rotor rotates to a certain angle, the two isolated The volume of the inter-tooth element is due to the convex teeth of the male screw invading the concave teeth of the female screw, and the volume of the element begins to shrink at the same time, realizing the compression process of the gas.
Until the moment when a pair of primitive volumes are connected to the exhaust orifice; after the primitive volume is connected to the exhaust orifice, the exhaust process of Quality Screw compressor Manufacturers china starts, and the exhaust process continues until the two teeth are completely meshing, that is, when the volumes of the two primitives are equal to zero due to the complete meshing of the two rotors.
Through the above introduction and analysis of the working process of Quality Screw compressor Manufacturers china, hope it helps you.