The ethane in the Ethane compressor is the second member of the alkane family and is the simplest hydrocarbon containing a carbon-carbon single bond. The structural formula is CH3CH3. The content of ethane in the Ethane compressor is 5% to 10% in some natural gas, second only to methane; and it exists in petroleum in a dissolved state.
This article will introduce the installation requirements of the Hydrogen Sulfide Compressor. 1. Requires a spacious and well-lit place, which is conducive to the operation and maintenance of the Hydrogen Sulfide Compressor. 2. The relative humidity of the air should be low, the dust should be less, and the air should be clean and well ventilated.
This article will introduce Installation Notes of Hydrogen Sulfide Compressor. Accessories for Hydrogen Sulfide Compressor are as follows: Cooler, air compressor accessories (valve), cylinder | cylinder head, cross head, cooler, valve, valve plate, crankshaft, connecting rod, head tile, piston rod, sealing ring, oil scraper ring, support ring.
This article will introduce the working principle and classification of compressors. High-pressure compressor is a type of compressor classified by pressure, and the exhaust pressure is 100-1000MPa. Its models are available in piston, membrane, screw and centrifugal compressors. Generally used as petroleum gas, natural gas, oilfield gas compressors in petrochemical industry, hydrogen compressors in oil hydrorefining, air and oxygen compressors in air separation, ethylene, propylene, propane, coke oven gas, Nitrogen, ammonia, Hydrogen Sulfide Compressor and other process compressors.
The acetylene used in the Acetylene Compressor is the simplest and the most important compound in the alkyne. Its chemical properties are very active, and it is easy to carry out addition and polymerization and other chemical reactions. The acetylene in Acetylene Compressor emits bright light and a lot of heat when it burns with oxygen or air, so it is widely used in industry. It is mainly used for welding and cutting of metals, analysis of medicine and instruments, basic raw materials for organic synthesis and marine lighting, etc.
The produced gaseous acetylene is filled with a compressor into a steel cylinder with a porous filler and a solvent (generally acetone), so that the acetylene gas is dissolved in the acetone liquid, and the acetylene gas is released from the acetone liquid when used, so that The acetylene is called dissolved acetylene. Process equipment to complete the processes of gas production, purification, compression, drying and filling required for dissolving acetylene. It has the advantages of large compression ratio, good sealing performance, energy saving, safety and reliability, reduction of pollution, convenient use and good gas quality.